(Handheld)ġ5.Be certain the work is securely clamped and will remain stationary during the routing operation. (Handheld)ġ4.Be certain that the motor is properly grounded. Inform him of the direction and order of feed you plan to use.ġ1.Make a trial cut on an extra piece of stock that is the same thickness as you project.ġ2.Always lock or unplug the machine when mounting bits or making major adjustments.ġ3.The bit must be securely mounted in the chuck to a depth of atleast 1/2” inch. Be certain the direction of feed is correct.ġ0.Have your instructor to inspect the setup. ![]() Snap the switch on and off quickly to check rotation of the cutter. ![]() Roll the spindle over by hand to check clearance of complicated settings. Cut only new stock that is straight, true and free of splits, checks and knots.ĩ. If the part is too small to allow this margin, design and build a special holder or push board.Ĩ. Maintain a 4” inch margin of safety when using the fence or miter gauge, and a 6” inch margin of safety when using depth collars. Use guards, feather boards and hold-down devices whenever possible.ħ. Be certain it is properly adjusted and securely locked in place.Ħ. Use the fence for all straight line shaping cuts. ![]() An approved lock washer must be located directly under the spindle nut. Any unused part of the cutter should be below the table.Ĥ. When possible, mount the cutter so that most of the cutting will be performed on the lower part of the edge. Be sure to have the instructors approval before operating the machine.ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |